This tab lets the user set the user settings. It is divided into two sections: one for the application-specific parameters and one for the configuration setting-specific settings. Application Settings Section: The upper section contains parameters that do not change regardless of which conversion setting is currently selected, if any. Currently, the only application parameter is the directory into which log files should be written. Its default value is the directory in which S2I currently executes. User Settings Section: This section contains user parameters specific to the selected conversion setting.These user settings are: INM directory: The directory to write the INM files to. Case directory: The subdirectory of the INM directory where the case-specific INM data (i.e. flight operations) should be stored. This display is enabled only after an INM directory is entered. Convert Runway Data: If checked, the SIMMOD runway information is read, translated, and written to the INM output files. This data is not converted if this check box is clear; however, users still need to map the runway identifiers. Desired Output Format: The user can choose from one of several output formats. DBF Database Format is the default. Airport Center Latitude: Latitude of the center of the airport in this INM study. Users can enter this value in a variety of formats. Airport Center Longitude: Longitude of the center of the airport in this INM study. Users can enter this value in a variety of formats. Maximum Study Range: The distance in nautical miles around the airport center beyond which the aircraft are too high to be audible from the ground. Beyond this limit, INM doe not care what the airplanes do. The INM directory; the airport center latitude and longitude; and the maximum study range must have values before a SIMMOD to INM conversion can be successful. The controls for these values are disabled when no conversion list is selected.